I didn't do a super clean job, but VO racks are pretty sloppy anyway. We'll see how it does this weekend.
Tuesday, November 26, 2013
In preparation for an uncoming camping trip I was trying to figure out a front rack for the Dirt Owl. On other bikes I have used the Nitto Mini Front rack with P clamps and it's always worked out fine. I was about to switch one over from another bike when, just for shiggles, I measured the reach of the legs and realized that they would land right on top of the canti studs on the new bike. If I had the time I could have ordered a Nitto Mark's rack from Riv, but with the holiday coming up I wouldn't get it in time. Then I remembered this crappy old VO Pass Hunter front rack that I had that wouldn't fit any of my bikes that had any decent tire clearance. (It did fit my wife's Bridgestone RB-T, but she never used it) Anyway, it still wouldn't work on the new bike unless I just hacked it up, and so that's just what I did.
Sunday, November 17, 2013
Panaracer driver 650b 2.2", velocity synergy rims, LX hub rear, old DT Swiss Hugi front
11-34 9 speed sram casette, xt rear der, campy triple front der, Sugino xd2 crank 46/36/24
old xt and avid v-brakes with tektro v-brake levers
9cm Nitto technomic stem, 46cm nitto Mark's bar, DA bar ends, FSA Duron headset, yokozuna cables/housing, Newbaum's tape
Cheapie seat post, brooks, old crummy pedals
Most of the build was chosen just beacuse it's what I had laying around. I chose the v-brakes just because I happened to have a pair and randomly had the correct levers. The campy front der and xt rear were scored at a rivendell garage sale a year ago, and while both work, I would have chosen others if buying them new. The newer xt rear ders dont have barrel adjusters on them and when used with bar end shifters there is no way to set them up to index properly. Adding a barrel adjuster to this derailleur is tricky as it has a strange location for the cable housing to enter. The Campy front has to be canted to the side to allow for the 24t chainring up front; the chain jambs up underneath it otherwise. I'm also currently just using some janky old plastic pedals until I figure out something better. The goal here was to figure out a decent build without sweating the ideal build too much.
Plenty of room here for a larger tire in the fork, though I might have to switch to cantilevers to get clearence on the stradle cable.
The front drop out after a little clean up
Tire clearance out back. The frame came out good for huge tire clearance. Also here you can see the tread pattern on the Panaracer Drivers. So far I really like them, and they feel fast and grippy.
The only big mess up on the frame is the bottom bracket. I had a hell of a time finding bottom bracket drop numbers for other ridgid 650b mountain bikes. I ended up just basing mine on the Rivendell Bombadil but going a few mm higher. Turns out that's still not enough to get good bb height and lessen the pedal strike. I'm going to end up running shorter cranks to see if I can get better results. Currently I've got 175s on there and I'm gonna try 165s. Seems short but I prefer to spin anyway and use low gears, this bike's lowest combo is 36 rear 24 front, pretty freaking low.